Skip to main content

ted21683

About

Location: United StatesMember since: 12 August 2011

All Feedback (304)

vip-marketplace (2772)- Feedback left by buyer.
Past 6 months
Verified purchase
Hope to deal with you again. Thank you.
hongtai888 (2749)- Feedback left by buyer.
Past 6 months
Verified purchase
Very nice buyer
base1233 (8808)- Feedback left by buyer.
Past year
Verified purchase
Quick response and fast payment. Perfect! THANKS!!
the_best_health (941)- Feedback left by buyer.
Past year
Verified purchase
Good buyer. Recommend to all sellers. Plz recommend us 2 your friends. Thx a lot
liftstrutstore (87286)- Feedback left by buyer.
More than a year ago
Verified purchase
Good buyer, prompt payment, valued customer, highly recommended.
metalhead39 (1479)- Feedback left by buyer.
More than a year ago
Verified purchase
Fantastic buyer. Great communication. Polite. Fast payment. Absolute pleasure.
Reviews (3)
1959-D 50C Franklin Half Dollar (Unc.)
11 February 2017
Great place holder! In a proof set!
This is a more than Adequate place holder till I can get a proof! Will buy many more of different yrs! It's not quite a proof but it sure won't stand out as dull! Very satisfied!
.308 / 308 Full Size TPI Competion Muzzle Brake 5/8x24 Pitch w/ Crush Washer
25 February 2018
Nice muzzle break but crush washer is way to stiff and doesn't allow proper timing. Still great muzzle brake.
400 ct CIGAR HUMIDOR DISPLAY CASE CABINET END TABLE
18 August 2018
Hard to say if I'd reccomend it.
There is practically no sealing to this humidor at all. A dollar bill can slide sideways between seals. The planks on the inside instantly peeled off the edges when I removed them from the top drawer. The exterior looks nice but there is absolutely no deal to keep humidity in. It is going to take a lot of work on my part to make this work before I put anything of value in it. Even the hygrometer barely stays in its place. I am starting an extensive seasoning process on it to see if the seals swell up any to make a reasonable deal. If not I will be attempting mold resistant silicone and felt tape around the closing points.if you have already bought a high quality humidor I'd stay away from this. If you have not already purchased one this is a good starter humidor that will take you a long time to outgrow. But the lid doesn't sit on flush, the one panel is slightly crushed. The hinges feel extremely cheap and would recomend to replace them. The glass on the top lid is loose and would cause excessive leaking. I guess the more I look at it the more I find problems with it.
5 of 5 found this helpful