About
All feedback (2,417)
- schaeferbros (6894)- Feedback left by buyer.More than a year agoVerified purchaseThanks for the purchase and prompt payment. Great eBayer! Item w/ USPS on 3/15/24
- oddrabbit (9138)- Feedback left by buyer.More than a year agoVerified purchaseGood buyer, prompt payment, valued customer, highly recommended.
- applebyattic (7766)- Feedback left by buyer.More than a year agoVerified purchaseGood buyer, prompt payment, valued customer, highly recommended AAAA++++++++++++
- makingdeals99 (5381)- Feedback left by buyer.More than a year agoVerified purchaseGood buyer, prompt payment, valued customer, highly recommended.
- briefmarken-haller-de (6179)- Feedback left by buyer.More than a year agoVerified purchaseReibungslose Kommunikation. Sehr angenehmer Geschäftspartner.
- run12660 (1130)- Feedback left by buyer.More than a year agoVerified purchaseGood buyer, prompt payment, valued customer, highly recommended.
Reviews (7)
13 June 2022
These work great - genuine GI
Since these are genuine GI contractor make (Picatinny Arsenal contracts), they should work fine in any real or clone M1911A1. I have fired four of them in a new SDS/Tisas clone, and they fed without any problems. Highly recommended.
01 June 2020
Not really speedy, but easy
I wouldn’t really call this a “speed loader,” but it is certainly MUCH easier than loading a magazine by hand, or with one of those little plastic rings that goes on your thumb. And it’s not that it’s really slow or anything, it’s just not real super fast.
Advertising may make you think these are made specifically for each different magazine, which is not the case. There seem to be two or three different models/sizes of these - A, B, and maybe C - depending on whether for single-stack or double-stack, cartridge size, etc. That is, the one you get for a .40 caliber SIG is the same one as for a 9mm SCCY. But the same one works well for both. It can be difficult to get the last cartridge to load, but it still works.
22 May 2020
Works just fine, easy to install!
Although this mirror was listed as "used," it looks and works like new - no scratches or marks on it. It was easy to install for one with moderate skill, using all available instructions. I saved time and effort by wiring it to the sunroof controller connector. You could also probably wire it to the map lights if you don't have a sunroof. The mirror I got had a 12-pin connector and the Toyota instructions are for a 10-pin connector, but correct wiring instructions came with the mirror. It was not difficult to figure out which wire went where. In addition to the auto-dimming feature, this mirror has the Homelink buttons to activate your garage door opener, and a compass readout. This is a great product and I wish I had put one in the last two cars I owned.