About
All feedback (624)
- r***o (295)- Feedback left by buyer.Past 6 monthsVerified purchaseI'm Very happy with the Chainsaw. It's better than I expected. I would definitely buy form the seller again. Shipping was a little late but not the sellers fault. It was shipped out fast
- 18psiwopen18 (277)- Feedback left by buyer.Past monthVerified purchaseGreat
- bigjimssmallengine53066 (670)- Feedback left by buyer.Past 6 monthsVerified purchaseImmediate Payment 👍👍 Highly Recommended
- *****- Feedback left by buyer.Past 6 monthsVerified purchaseHope to deal with you again. Thank you.
- haracenter3 (47206)- Feedback left by buyer.Past 6 monthsVerified purchaseGood buyer, prompt payment, valued customer, highly recommended.
- eBay automated Feedback- Feedback left by buyer.Past 6 monthsThis seller successfully completed an order.
Reviews (6)
13 April 2017
Failed after two days.
Used this as a replacement for my original water valve in my KitchenAid refer (OEM part no longer available). The second night after installing it, I was about to fall asleep when I heard water running. Ran up to find the in-door water dispenser running wide open. Somehow, the rubber sealing washer had slipped out of position and was letting water flow. Lucky I was home and not yet asleep when it failed. Was able to use the "pistons" out of this assembly to repair the original KitchenAid valve (which seems to be a much better design).
11 August 2017
Fuel screw does not fit.
I purchased this kit because I needed the float bowl o-ring and I wanted to add the extended fuel screw. For not much more than the cost of these items individually, I was able to purchase the entire kit. Unfortunately, the extended fuel screw doesn't work on the Keihin FCR carburetor that comes on the DRZ400E/K. (Should work on the "MX" FCR carb.) Still not a bad value if you need more pieces out of the kit but you'll have to order a remote fuel screw or modify the one that comes with this kit. (The passage for the screw has to be drilled out a bit and I had to grind the knurles off the extended fuel screw). AllBalls did sent another STOCK fuel screw when I contacted them but that's not what I ordered/paid for. Their packaging clearly states the kit is for the non-California DRZ400E/K.
16 August 2017
41T sprocket.
Heavier than the stock AL sprocket but much less expensive and should wear well. Good fit and quality. 15T - 41T gearing for road/highway on my DRZ400E. Tall gearing but I think it will be OK.