vk5la on eBay

About

Location: AustraliaMember since: 05 January 2001

Feedback ratings

Last 12 months

Positive55- positive feedback in last 12 months

Neutral0- neutral feedback in last 12 months

Negative0- negative feedback in last 12 months

All feedback (642)

ercxswr347 (55552)- Feedback left by buyer.
Past month
Verified purchase
Good buyer, prompt payment, valued customer, highly recommended.
midnorthcoastcomponents (22944)- Feedback left by buyer.
Past month
Verified purchase
Hope to deal with you again. Thank you.
phippselectronics (9852)- Feedback left by buyer.
Past month
Verified purchase
Quick and pleasant transaction, enjoy your purchase! Phipps Electronics.
tronfx (52017)- Feedback left by buyer.
Past month
Verified purchase
Quick response and fast payment. Perfect! THANKS!!
hiphop2018 (2103)- Feedback left by buyer.
Past month
Verified purchase
Thank you very much!
*****- Feedback left by buyer.
Past month
Verified purchase
Good buyer, prompt payment, valued customer, highly recommended.

See all feedback

Reviews (10)

Microphone Stand Broadcast Mic Studio Desktop Suspension Boom Scissor Arm Holder

12 June 2017

Not a Rode PSA1, but not bad!!!

If you've looked at the Rode PSA1, and then considered one of these, then bear in mind that these ARE NOT A FULL SIZE BROADCAST ARM. They are what I would describe as 3/4 size, compared to a PSA1. However aren't bad for the price. It is suitable for a small desk, say up to 500mmm or 600mm deep. anything deeper than that and the arm will be hyper extended, and be too close to the desk. It's not an issue with a sparse desk, but will become an issue if your desk space is limited. The steel used in the construction, quality of the hardware and finish seem reasonable for the money, but the desk clamp and the way the actual arm mounts to the desk clamp is a bit of a let down. It's cheap, and you cant sugar coat it. I ended up chopping the cable and connectors off that came supplied, as the shield in the cable wasn't very substantial, although the centre conductors had foil shielding. The actual XLR connectors they've used aren't too bad though. As I had heaps of spare cable and connectors, I opted to upgraded it. My environment is Amateur Radio, so I need it to be quiet and RF interference proof. All in all it's a good buy. 3 and 1/2 stars

CP2102 MICRO USB to UART TTL Module 6Pin Serial Converter STC Replace FT232 ZX

04 May 2017

Good replacement for the units that were bricked by FTDI

These are great, get the job done!

JOYO JF-37 ANALOG CHORUS Electric Guitar Effect Pedal with True Bypass X6Q2

03 October 2019

Yes!

If your looking for a Boss CE-2 clone that actually sounds like one, then you’ve just found it

See all reviews