- All
- New
- Pre-owned
5stars
60ratings4stars
13ratings3stars
1rating2stars
1rating1star
3ratings
Would recommend94% agree
Good value95% agree
Good quality95% agree
67 reviews
A Good Primary and Great Backup Heat Source
This replaced a 40 y/o unit that worked, but not well. Having the remote control makes temperature control much easier. The high mode provides instant heat when used and the guide vanes direct the flow well. I did replace the circuit breaker as this unit has a max draw of 31.4 amps (7500 watts)on high mode, and insured the wiring and connections were proper. It's below freezing outside and this unit cycles and maintains 63-68 degrees with a 72 degree setting. The area is an insulated 900 sqft and the temperature is read on the wall furthest from the unit. Until I get a better primary heat source this is a great unit to have till then.Read full review...
Verified purchase: Yes | Condition: new | Sold by: fordsfantasticf...
Not Happy
Not happy with this heater. First of all, the thermostat is not correct, as it is located INSIDE the heater where it stays hot. Must be set much much higher for desired temp. Second, and worst of all, when the heater switches ON or OFF, it makes a extremely loud BANG. Really disappointing for the price and would return it if it wasn't hard wired in. Regret buying the warranty, as I don't plan on keeping past it's first breakdown.Read full review...
Verified purchase: Yes | Condition: new | Sold by: sport_outdoors
The heater is built pretty tough
The heater is built pretty tough, which is a good thing. I also found it easy to connect, which interestingly enough was more expensive for the materials than it was for the heater. Only problem is that it doesn't heat as well as advertised. It claimed to heat an area (uninsulated) that was 30x30. my garage is 25x35 so I figured that was basically the same thing. after running for an hour or more it only brought the temp up from 45* to about 52*. I guess that if I left it running all the time it would eventually gey there, but that was not what I was hoping for. Plus, those temps were only for the emediate area around the heater, the far end of the garage was still ice cold. In any account it is a good heater for the price. especially if you already have a place wired for it.Read full review...
Verified purchase: Yes | Condition: new | Sold by: mr_brands_llc
Heater
Havent used it yet, but looks nice. It's smaller than I thought but as long as it heats good then I'm ok with it. I was a little disappointed that it didnt come with the plug. Luckily I have an extra one. I will have it hooked up in a couple of days. Thanks. Read full review...
Verified purchase: Yes | Condition: new | Sold by: premierindustri...
Meh...
Installed in my 2 car garage, used the correct 8ga wire and double pole breaker. On high setting, it trips the breaker. Tried a different breaker, no luck. It doesn't heat the garage as well as I anticipated, but better than having no heater at all. I like the remote, it works well. Heater is quiet. Not impressed but whatever. I may end up moving it to my basement, where I believe it may work better. Read full review...
Verified purchase: Yes | Condition: new | Sold by: b0PjKthKQtK@Del...
comfort zone cz230er
After researching different heater I found this to be the best deal, but the heat sensor is on the inside witch makes it shut off sooner than it should so I located it on the outside and it now works good. I also looked on youtube to see how to hook up 220w and found it to be really easy but make sure you use 8/3 wire and a 40amp double pull breaker for safety reasons. I have a 24x30 insulated garage with 8 foot ceilings and at 32 degrees it will heat up at about 10 degrees an hour and after a while when the heat is up a little bit it seems to heat up faster so I use my kerosene heater to speed things up a little and when it gets around 68 degrees this heater can maintain very easy. now just so you know I have 4 metal cars in my garage that retain cold air for quite a while so your garage might heat up faster depending what you have in itRead full review...
Verified purchase: No
New heater for shop
I purchased this unit to replace my old one. The unit arrived very quickly. I think it took 4 days to get to me. Packaging was very stout, no damage to the unit. I did have a friend of mine help me install it but it wasn't really hard and could have done it in a pinch. Instructions were easy to read. I have a 25x25 sq ft shop, insulated to about R4 and this heater does a nice job of warming it with outside temps around around 32F.
This unit is also nice in that I have a choice of hi or lo elements used to heat.
I would recommend this and install it myself if I go to a larger building.Read full review...
Verified purchase: Yes | Condition: new | Sold by: mr_brands_llc
Good Heatet
Great price, great size, easy to use
Verified purchase: Yes | Condition: new | Sold by: mr_brands_llc
Needs a temperature sensor not attached to the unit.
The temperature sensor is mounted in a way that the heater cuts off way before room temperature is reached. Believe the sensor is getting reading from the case rather than ambient temperature.
Verified purchase: Yes | Condition: new | Sold by: mr_brands_llc
Awesome
Well Made. Easy to use. Shipping was fast, with damage. Easy to install. Easy to hang. Would highly recommend it if the square footage is right and it is insulated.
Verified purchase: Yes | Condition: new | Sold by: premiumitemsny