Product ReviewsNeilsen CT2102 Timing Tool Set for VW Lupo/Polo

Works perfectly when used as intended!

Firstly, this tool is NOT intended to hold the camshaft in position while you loosen or tighten the bolt holding the camshaft sprocket to the cam (the torque setting for which is 50 Nm + 90 degrees). If you believe that it could possibly absorb that much torque without breaking (as another buyer clearly did) then you really should not be working on anything mechanical. Its purpose is to hold the cams in the correct position relative to the crankshaft so the valve timing is correct when you change the timing chain, a function it performs perfectly well. A completely different tool is available to hold the cam sprocket when loosening or tightening its retaining bolt.Read full review...

Verified purchase:  Yes | Condition: new | Sold by: homepromart

Shockingly bad tool

The pins that lock the camshafts snapped off upon first use. Terrible, cheaply manufactured piece of kit

Verified purchase:  Yes | Condition: new | Sold by: hippoproduct

crankshaft tool does not fit

The Cam shaft tool worked a treat.
The crankshaft tool was to big & needed adjusting which was a real pain, the was on a 07 fox 1.2 engine.

Verified purchase:  Yes | Condition: new | Sold by: winatlast1

Avoid.poor quality.

Looked fine but crank lock pin was .6mm to big and had to be turned down too fit.then can locking tool failed ( sheared) when replacing timing chain.big waste.not recommended!

Verified purchase:  Yes | Condition: new | Sold by: hippoproduct

Solidly made

excellent quality definitely compatible to the much more expensive manufacturers product.

Verified purchase:  Yes | Condition: new | Sold by: autotoolsdirect

cart do the job with out it

cheap to buy not the best but dose the job

Verified purchase:  Yes | Condition: new | Sold by: sunrisetools

Do not buy

Do not buy,
Poor quality, poor fitment, broke on first use had to strip head off car again to retrieve broken parts

Verified purchase:  Yes | Condition: new | Sold by: hippoproduct

Cam timing kit (Budget)

Great little kit for occasional use at a fifth of the cost of an OME kit. Ideal for DIY mechanic but not commercial use.

Verified purchase:  Yes | Condition: new | Sold by: hippoproduct

Not up for the job much to brittle

It broke the first time I used it

Verified purchase:  Yes | Condition: new | Sold by: hippoproduct

Alright, engineered just ok to get it into the block

Verified purchase:  Yes | Condition: new | Sold by: sunrisetools