Product ReviewsSmall Bearing Separator Splitter Puller 2" Inch Remover 50 Mm Capacity Auto

Exactly what I needed.

The right tools for the job. This is the only tool to use for bearing removal in close proximity to other bearings or other interferences. I tried several times with other cobbled up rigs with no luck. This tool pulled the race off in less than 30 seconds. Got one for next time. Read full review...

Verified purchase:  Yes | Condition: new | Sold by: imarketpro

Good for. Few times but a product that will

It worked but everytime I use it it wears out a little more. The base metal is to soft. A USA made Snap-On is much better and last longer and is warranted fii or r life. But in a pinch this work for awhile. Read full review...

Verified purchase:  Yes | Condition: new | Sold by: imarketpro

Great Product

I didn't want to spend $40 on an OTC since I probably will not use it again. Worked just fine, even if the bearing is too small, you can sling it in a vice and tap the bearing off.

Verified purchase:  Yes | Condition: new | Sold by: skyhawktools2013

Got it. It was too big for the project. I'll put it in the tool box and have it for someday.

Verified purchase:  Yes | Condition: new | Sold by: skyhawktools2013

Handy Tool

A strong bearing separator in the size I needed. Not used often, but no time to look for one when a job presents itself. I have jerry rigged tools to do this intended work in the past, not fun, and not efficient.Read full review...

Puller

Worked good for what it does.

Good bearing puller

Good bearing puller, thanks

Did the job

Did the job

Verified purchase:  Yes | Condition: new | Sold by: imarketpro

Very grafutel thanks.

Very grafutel thanks.

Good ítem

Good ítem

Verified purchase:  Yes | Condition: new | Sold by: greenmom1979